Earthworks FMR720/HC

Earthworks FMR720/HC

Earthworks FMR720/HC

Earthworks FMR720/HC

27" Hypercardioid Podium Microphone with rigid center and flex on both ends - 20Hz-20kHz

MAP: $499.00


The Earthworks FlexMic™ Series podium microphones are designed for permanent installation in podiums and other surfaces for speech applications.Whether it is a seasoned professional or a public speaking novice stepping up to the microphone, the FlexMic™ has you covered. Optimized for speech, the FlexMic™ microphones feature a flat frequency response out to 20kHz and excellent phase response that delivers the highest level of speech intelligibility and articulation.

The near-perfect polar response of the FlexMics provides incredible coverage and freedom of movement for the speaker. Whether speaking above, below or to either side of the microphone, every word will be reproduced with incredible clarity and intelligibility up to 90 degrees off-axis. This wider coverage also means that a single Earthworks microphones can be used to properly cover more than one speaker.With 32dB or rear rejection, the FlexMic™ delivers more gain before feedback and exceptional isolation from unwanted sound sources.

Ideal for civic, corporate, court, government or worship spaces.The FlexMic™ microphones feature a slim yet sturdy 7mm gooseneck that stays put when adjusted, while providing low profile sightlines. The gooseneck utilizes the latest in flex materials to virtually eliminate handling and movement noise.A metal mesh windscreen coupled with layers of foam prevent the loud pop inducing bursts of stop consonants from reaching the microphone. For outdoor events, an additional foam windscreen accessory  is available to help eliminate noise from high mph winds. Optional  permanent mount accessory available separately.The FlexMic™ microphones are available in 13, 19, 23 and 27 inch lengths. Fully flexible and rigid center goosenecks are available. Available in cardioid or hypercardioid.


  • Uniform frequency response on or off-axis

  • Flat from 50Hz to 40kHz within ± 2dB at 12 inches

  • Will handle up to 139dB SPL

  • No handling noise

  • High rejection of sounds to the rear of the microphone

  • RFI resistant

  • Incredible gain before feedback

  • Orators can speak above, below or to either side of the microphone and maintain the same pristine sound quality with high intelligibility


Frequency Response

 100Hz to 20kHz

Polar Pattern



 20mV/Pa (-34dBV/Pa)

Power Requirements

 24 – 48V Phantom, 10mA

Max Acoustic Input

 139dB SPL


 XLR (pin 2+)

Output Impedance

 65Ω balanced (between pins 2 & 3)

Min Output Load

 600Ω between pins 2 & 3


 16dB SPL equivalent (A weighted)


 .25 lb. (25g)