DPA ST4006A

4006A Stereo Pair with Clips and Windscreens in Peli Case

SKU: DPA-ST4006A

MSRP: $5,400.00

MAP: $5,400.00

Description

Overview

The DPA ST4006A is a complete DPA 4006A Stereo Pair with two carefully factory-matched omni microphones. Even though the standard tolerances on DPA Reference Standards are extremely low, a stereo match is even closer.
The specially selected DPA 4006A microphones are matched within ±0.5 dB on both frequency response and sensitivity. The maximum phase response difference is 5°.
The natural sound, high sensitivity, low noise-floor and extremely linear frequency response from 10 Hz to 20 kHz (±2 dB) of the microphone pair makes the ST4006A the perfect choice for all AB Stereo recordings. The design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory foam inlays.

Features

Carefully matched microphones
High sensitivity, low noise-floor and extremely linear frequency
Peli case transportation and protection

Specifications

Directional pattern: Omnidirectional
Principle of operation: Pressure
Cartridge type: Pre-polarized condenser
Frequency range: 10 Hz - 20 kHz
Frequency range, ± 2 dB: 10 Hz - 20 kHz
Sensitivity, nominal, ± 2 dB at 250 Hz: 40 mV/Pa; -28 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 27 dB (max. 29 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 79 dB(A)
Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
Dynamic range: Typ. 124 dB
Max. SPL, peak before clipping: 147 dB
Switchable attenuator: 0 dB / -20 dB
Output impedance: < 200 ohm
Minimum load impedance: 2 kohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 60 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color: Matte black
Weight: 163 g (5.7 oz)
Microphone diameter: 16 - 19 mm (0.6 - 0.75 in)
Capsule diameter: 16 mm (0.6 in)
Microphone length: 170 mm (6.7 in)
Output voltage, RMS: > 5 V
Polarity: +V at pin 2 for positive sound pressure