DPA 5006A

Surround Kit with 5 x 4006A, Clips, Windscreens in Peli Case

SKU: DPA-5006A

MSRP: $12,400.00

MAP: $12,400.00

Description

Overview

The DPA 5006A is a complete DPA 4006A Surround Kit with five carefully factory-matched omni microphones. Even though the standard tolerances on the d:dicate Recording Microphones are extremely low, the surround match is even closer. The specially selected DPA 4006A microphones are matched within +/-0.5 dB on both frequency response and sensitivity from mean of set. The maximum phase response difference is 5deg.. The natural sound, high sensitivity, low noise-floor and extremely linear frequency response from 10 Hz to 20 kHz (+/-2 dB) of the microphones make the DPA 4006As the perfect choice for all AB Stereo, Decca Tree or surround main array recordings. The precise reproduction, total transparency and natural-sounding clarity of a DPA 4006A microphone will provide you with a lifetime of satisfying listening. The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory.

Included in this kit
Carefully matched microphones, sturdy Peli case, holders, grids and windscreens.

Features

Five carefully matched microphones
Perfect for Decca Tree + rear omnis surround array
Specially useful for acoustically accurate reproductions
Peli Case transportation and protection

Specifications

Directional pattern: Omnidirectional
Principle of operation: Pressure
Cartridge type: Pre-polarized condenser
Frequency range: 10 Hz - 20 kHz
Frequency range, ± 2 dB: 10 Hz - 20 kHz
Sensitivity, nominal, ± 2 dB at 250 Hz: 40 mV/Pa; -28 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 15 dB(A) re. 20 µPa (maks. 17 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 27 dB (max. 29 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 79 dB(A)
Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
Dynamic range: Typ. 124 dB
Max. SPL, peak before clipping: 147 dB
Switchable attenuator: 0 dB / -20 dB
Output impedance: < 200 ohm
Minimum load impedance: 2 kohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 60 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color: Matte black