Shure MX183

Shure MX183

Shure MX183

Shure MX183

Subminiature Lavalier Microphone, omnidirectional, condenser, includes preamp

SKU: SHU-MX183
MSRP: $344.00
MAP: $246.00

Microflex® Live Sound > Microphones > Wireless Microphones > Lavalier Microphones bring a new level of sophistication to personal voice reproduction. Like all Microflex family microphones the Lavaliers use Shure's interchangeable condenser Live Sound > DJ Equipment > Cartridges available in cardioid supercardioid or omnidirectional polar patterns. That means you can be sure there is a Microflex Lavalier that's right for your application.  Compatible with all Shure wireless bodypack transmitters their high sensitivity and wide frequency response guarantee great sound.

MX183: Omnidirectional Includes Belt-Clip Preamp Rotatable Tie Clip Dual Tie Clip Snap-Fit Windscreen

MX184: Supercardioid Includes Belt-Clip Preamp Rotatable Tie Clip Dual Tie Clip Snap-Fit Windscreen

MX185:  Cardioid Includes Belt-Clip Preamp Rotatable Tie Clip Dual Tie Clip Snap-Fit Windscreen

  • Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
  • Interchangeable Live Sound > DJ Equipment > Cartridges that provide an optimal choice for each application
  • Rotatable tie-clip that pivots in 90 degree increments for placement flexibility
  • Supplied snap-fit foam windscreen that controls breath noise and stays on securely
  • Balanced transformerless output for increased immunity to noise over long cable runs
  • Supplied dual tie clip holds two microphones for dual miking applications

SPECIFICATIONS

MX183 Microflex Lavalier Microphone

  • Type: Condenser (electret bias)
  • Frequency Response: 50 to 17,000 Hz
  • Polar Pattern: Omnidirectional
  • Output Impedance: EIA rated at 150 ohms (180 ohms actual)
  • Open Circuit Sensitivity (at 1 kHz, ref. 1V/Pascal*): -27.5 dB (42.2 mV); All settings -12 dB at 0 gain *1 Pascal = 94 dB SPL
  • Max SPL (1kHz at 1%THD, 1 k ohm load): 116.7 dB; All settings +6 dB at 0 gain
  • Equivalent Output Noise (A-weighted): 20.5 dB
  • Signal to Noise Ratio (referenced at 94 dB SPL):73.5 dB
  • Dynamic Range at 1 k ohm load: 96.2 dB; 100 dB at 0 gain
  • Power Requirements: 11 to 52 Vdc phantom, 2.0 mA
  • Common Mode Rejection: 45.0 dB minimum
  • Polarity: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector.
  • Environmental Conditions: Operating Temperature Range: -18 to 57 degrees C (0 to 135 degrees F); Storage Temperature Range: -29 to 74 degrees C (-20 to 165 degrees F)
  • Cable: Shielded 1.2 meter (4 ft.) cable terminated with a 4-Pin Female Mini Connector (TA4F)
  • Dimensions (length x diameter): 3.89 " x .79" (99 x 20 mm)