Overview
The Neumann TLM170RMTSTEREO Factory-Matched Stereo Set of Two TLM170RMT with EA170MT in Mic Briefcase | Matte Blackdoubles the quality and sound of the famed condenser microphone by including two factory matched microphones in this kit. Achieve excellent stereo recordings of instruments, performances, ambiance and more. Two shock mounts and a storage case is also included.
Matt Black Finish
The TLM 170 RMT features a non-reflective black matt finish, making the microphone less conspicuous in live sound and broadcast applications.
FET Design
FET 100 technology along with a balanced, transformerless output stage result in high gain and low noise audio output.
5 Polar Patterns
Omni-directional, wide angled cardioid, hyper-cardioid and figure eight are all available.
Transparent Output Signal
The TLM 170RMT features a flat frequency response curve, resulting in clean, transparent audio reproduction without signal coloration.
Features
- Local and remote controlled large diaphragm microphone
- Pressure-gradient transducer with double membrane capsule
- Five directional characteristics: omni, wide angle cardioid, cardioid, hypercardioid, figure-8
- Patented circuitry for remote and local switching of directional characteristics
- Switchable low frequency roll-off and 10 dB preattenuation
- Tiltable, elastically suspended bracket mount
Specifications
Acoustical operating principle | Pressure gradient transducer |
Directional pattern | Omnidirectional, wide angle cardioid, cardioid, hypercardioid, figure-8 |
Frequency range | 20 Hz ... 20 kHz |
Sensitivity at 1 kHz into 1 kohm | 8 mV/Pa |
Rated impedance | 50 ohms |
Rated load impedance | 1 kohms |
Equivalent noise level, CCIR | 26 dB |
Equivalent noise level, A-weighted | 14 dB-A |
Signal-to-noise ratio, CCIR (rel. 94 dB SPL) | 68 dB |
Signal-to-noise ratio, A-weighted (rel. 94 dB SPL) | 80 dB-A |
Maximum SPL (tube characteristic) for THD < 0.5 % | 144 dB |
Maximum SPL (tube characteristic) for THD < 5 % | 154 dB |
Maximum output voltage | 10 dBu |
Dyn. range of the mic. amplifier (A-weighted, 0.5 %) | 130 dB |
Supply voltage (P48, IEC 61938) | 3 mA |
Matching connector | XLR 3F |