- Light engine: LED 7 x 40W RGBW
- Full-gamut color calibration
- CTC control: 1,800–12,850 K
- High output: 3,700 lm
- High intensity 397,783 cd
- Zoom: 4.2 - 58˚
- Low-noise cooling system
- High-speed pan, tilt & zoom
- Weight 7.3 kg (16.1 lbs.)
- Dimensions: 276 x 176 x 356 mm (10.9 x 7.0 x 14.1 in.)
Specifications
Physical
- Length: 276 mm (10.9 in.)
- Width: 176 mm (7.0 in.)
- Height: 356 mm (14.1 in.)
- Weight: 7.3 kg (16.1 lbs.)
Dynamic Effects
- Color mixing: RGBW
- Color presets: 48 color presets, virtual color wheel effects
- Color temperature control: Variable 1,800 - 12,850 KEl
- ectronic dimming: 0 - 100%, four dimming curve options
- Strobe and pulse effects: Variable speed and action, random strobe
- Electronic shutter effect: Instant open and blackout
- Zoom: Motorized, 4.2 - 58°Pan: 540°Tilt: 260°
Construction
- Housing: High-impact flame-retardant thermoplastic
- Color: Black
- Protection rating: IP 20
Installations
- Mounting points: 2 x quarter‐turn fastener receptacles, 106.5 mm
- Location: Indoor use only, must be fastened to surface or structure
- Orientation: Any
- Minimum distance to combustible materials: 0.5 m (1.7 ft.)
- Minimum distance to illuminated surfaces: 1 m (3.3 ft.)
- Minimum clearance around fan and air vents: 0.5 m (1.7 ft.)
Connections
- AC power input/output: Neutrik PowerCON TRUE1 TOP
- DMX and RDM data in/out: Neutrik 5-pin locking XLR
Control and Programming
- Control options: DMX, RDM
- DMX channels: 1816-bit fine control: Dimming, RGB, zoom, pan and tilt
- LED color management modes: Raw, extended and calibrated
- DMX address setting: Control panel with LCD display
- DMX compliance: USITT DMX512-ARDM compliance: ANSI/ESTA E1.20Fixture software update: USB memory device or over DMX link
Optics
- Light source: 7 x 40 W RGBW Osram LEDs
- Minimum LED lifetime: 50,000 hours (to >70% luminous output)*
- Beam angle (half-peak): 4.2° - 38.7°Field angle (one-tenth peak): 5.1° - 58.6°Cutoff angle (3%): 5.7° - 69.6°
- Binning: Tight color and flux binning
- Calibration: Full Gamut Color Calibration
- *Figure obtained under manufacturer's test conditions
Photometric Data
- Wide beam: 3700 lumens
- Narrow beam: 1774 lumens
- Fixture Center Intensity Narrow Beam: 397783 cd
- Fixture Center Intensity Wide beam: 10042 cd
- CRI (Color Rendering Index) : >70CQS (Color Quality Scale): 83
- TM-30 Rf (IES TM-30-15 Fidelity Index): 77
- TM-30 Rg (IES TM-30-15 Gamut Index): 117
- TLCI (Television Lighting Consistency Index): 56CCT: 6500 Kelvin
- LED refresh rate - Standard Mode: 3600 Hz
- LED refresh rate - Theatre Mode: 19200 Hz
Electrical
- AC power: 100-240 V AC nominal, 50/60 Hz
- Power supply unit: Auto-ranging electronic switch mode
- Typical half-cycle RMS inrush current at 240 V, 50 Hz: 8.7 A
- Power Factor: 0.99 @ 100 V / 120 V , 0.97 @ 220 V / 230 V / 240 V
- Typical current draw: 3.8 A @ 100 V / 120 V , 1.5 A @ 220 V / 230 V / 240 V *
Power Consumption
- Typical: 315 W *
- * Measurements made at nominal voltage. Allow for a deviation of +/- 10%.
- Typical: full output white, no effects moving, regulated fan speed.
Thermal
- Cooling: Forced air (temperature regulated, low noise)
- Maximum ambient temperature (Ta max.): 40° C (104° F)
- Minimum ambient temperature (Ta min.): -10° C (14° F)
- Total heat dissipation (calculated): 1195 BTU/hr.
- *Calculated, +/- 10%, at full intensity, full white
- LWR*: 507 lm/kg (230 lm/lb)
- LWR = Lumen-to-Weight Ratio
Environmental
- RoHS: Compliant
- REACH: Compliant
- WEEE: Compliant
- Proposition 65: Compliant
- Efficacy (max output): 15.5 lm/W
Approvals
- Global CB Certification/IECEE: IEC 60598-2-17 (IEC 60598-1)
- EU safety: EN 60598-2-17 (EN 60598-1), EN 62471, EN 62493
- EU EMC: EN 55015; EN 55032; EN 55035; EN 61000-3-2, EN 61000-3-3, EN 61547
- US safety: UL 1573US EMC: FCC Part 15 Class B
- Canadian safety: CSA C22.2 No. 166Canadian EMC: ICES-003 Class B, ICES-005 Class B
- Australia/NZ: RCM
- United Kingdom: UKCA
