Overview
The M2T half-rack transmitter houses two stereo transmitters to provide two stereo audio channels, and for up to four mono audio channels in a single rack space. The audio inputs can be individually configured to be analog or Dante compatible. The analog input connectors are full-size XLR/TRS combo types for balanced line-level analog signals while the input preamp circuits use a special balanced amplifier with very high common mode rejection to minimize hum and noise. A Dante™ Ultimo™ interface via dual RJ45 connectors accepts Dante networked audio inputs and can daisy chain the digital stream to additional units via CAT6 cables. An additional RJ45 jack provides an Ethernet connection for programming and control via Wireless Designer™ software and a USB jack on the front panel allows for firmware updates. The transmitter features a full color, backlit LCD for high visibility in any environment, while the chassis is all-metal and can be racked singly or in pairs using included rack mount hardware.
Features
- IEM (Wireless Monitor) with digital RF transmission
- 2 independent stereo audio transmissions per 1/2 RV enclosure
- USB port for firmware updates
- Fully Dante™ compatible
- IR (infrared) port for fast setup
- Up to 50 mW per Rf carrier
- All metal housing
- Compatible with Wireless Designer™ Software
Specifications
- RF Power Output: 2 RF carriers, 25 mW, 50 mW; adjustable
- Antenna Output: 2 x BNC sockets
- Operating Frequencies: 470.1 - 607.975 MHz
- Frequency Selection Steps: 25 kHz
- Frequency Stability: ± 0.002%
- Modulation: 8 PSK
- Emission Designator: 200KG7E
- Spurious Radiation: > 90 dB below carrier
- Equivalent Input Noise: -128 dBV
- Audio Frequency Response: 20 Hz - 15 kHz, -3 dB
- Audio Input: -10 dBv or +4 dBu settings w/ ± 5 dB trim
- Audio Input Jack: 4 x combo XLR/TRS connectors
- Ethernet Connection: RJ45
- USB Connection: Micro USB on front panel for firmware updates
- IRDA: IR transceiver for sync of receivers
- Input Impedance: Line: 2k Ohm
- Headphone Jack: 1/4 inch stereo jack
- Power Requirements: 9-18 V DC
- Power Consumption: 5 Watts
- Dimensions (H x W x D): 1.75 x 8.375 x 7.75 in | 44.45 x 212.7 x 196.8 mm
