Overview
The DNT16i processor provides inputs into a Dante network from analog and digital signals. Each input provides extensive signal processing and routing to any one or all of 48 automatic mixers operating at the crosspoints of an internal digital matrix in the processor. The outputs of the matrix can be assigned to a Dante transmit channel and/or routed back to an input to be further mixed with another input or matrix mix.
Features
- 16 mic/line analog inputs with 48V phantom power and wide range gain control
- 16 DanteTM digital inputs
- 32 DanteTM digital outputs
- Supports both switched and redundant modes in DanteTM operation
- Pre-mixing signal processing on all 32 inputs (analog and digital)
- 48 independent automatic mixers with 36 inputs per mixer and channel activity detectors
- Support for multi-level mixing: mixes can be looped back and used as mixer inputs
- Extensive signal processing including filters, delay and channel linking for dynamic processing (compressors, limiters)
- Gain smoothing to prevent transient noise during instantaneous level changes
- Four test signal generators available for system setup and testing
- Extensive macro command language
- Control interfaces via USB, RS-232, Ethernet and programmable logic I/O
- Rack mount or under table mount
Specifications
| Audio inputs: | |
| Channels: | 32 total; 16 analog mic/line; 16 Dante digital |
|
Max. input level:
|
20 dBu |
| Gain: | Analog: 0 dB to 56 dB, programmable in 8 dB steps (the analog gain is automatically set by selecting the input gain) Digital [Dante]: -70 dB to +20 dB |
| Input impedance: | 8 kΩ differential mode, 2 kΩ common mode |
|
Phantom voltage:
|
48 V
|
|
Dynamic range:
|
102 dB
|
|
EIN:
|
-127 dBu (20 Hz – 20 kHz, unweighted)
|
|
THD + noise:
|
0.01%
|
|
A-D Sampling Rate:
|
48 kHz; fixed |
| Audio outputs: | |
| Channels: | 32 digital outputs delivered to the Dante network |
| Dante Interface: | |
|
Supported sampling rate:
|
48 kHz
|
|
Data rate LED:
|
100Mbps/1Gbps
|
|
Activity LED:
|
blinks when active
|
|
Modes of operation:
|
Switched mode using either connector Redundant mode with primary and secondary networks using both connectors |
| Network Connectivity: | Dante interface and Ethernet control can be connected to the same network |
| Filters: | |
|
Tone control stages:
|
4 per input channel
|
|
ADFE:
|
8 per input channel; configurable as static or dynamic |
| Internal Signal Generator: | |
|
White noise parameter:
|
Level [dBu]
|
|
Pink noise parameter:
|
Level [dBu]
|
|
Tone (sine wave) parameters:
|
Level [dBu], frequency |
|
Power Requirements:
|
100-240 VAC, 50/60 Hz
|
|
Power Consumption:
|
20 W maximum
|
|
Dimensions:
|
1.75 x 19.00 x 7.70 inches
|
|
Weight:
|
5.32 lbs., 1.7 kg
|
