Overview

Dual Sequenced 20 AMP Power Distribution System with Remote Control Capability

When is more than one sequence event needed?
Whenever it's a good idea to reduce the start-up current surge on a single circuit. That's why the CQ-2200 has 2 sequence events...and why it's so popular.

Some amplifiers may be able to operate in tandem on a single 20 amp circuit, but would overload the circuit if turned on at the same time. The CQ-2200 stages the turn-on thereby reducing the required electric power service.

For smaller systems the CQ-2200 can act as a stand alone sequencer, activating front end equipment on the first POD and the amplification on the second.

Because the CQ-2200 can be controlled by a contact closure, installation is quick and requires no expensive accessories. Remote activation is very simple and convenient.

So, the CQ-2200 offers several attractive features in a very economical, easy to install and easy to use package. The CQ-2200 is available in an isolated ground version (CQ-2200-IG).

Specifications

• Chassis: 16 gauge steel – mounts through holes in back box
• Dimensions: 5.5”H x 6.4”W x 3.75”D
• Weight: 5 lbs
• Circuit Breaker: 20A thermal on side of the chassis
• Relay Current Rating: 30A
• Number of Sequence Events: Two
• Power Input: Hard wire through strain relief on back box
• Power Output, NEMA 5/20R: Four
• Input Voltage: US standard (120 VAC @60Hz)
• Signal Connections: RJ-45, eight wire cable
• Monitor Features: Monitor lights correlate to processor and relay operation