Overview
Install an M-8Dx into the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load. Illuminate your rack with two retractable, front panel lights. Monitor voltage with the digital meter display.
INSTRUMENT RIGS
You’ve got a rack for your effects, preamps, tuner… You’re going to plug that into the wall? One big spike and your rig is up in smoke. Standard level surge/spike protection from Furman defends your gear from the spikes and surges that are so common at gigs and practice spots. With standard level RFI/EMI filtration from Furman, you’ll get a quieter tone without pops, crackles, and the local radio station coming out of your amp. Plus, dual pull-out lamps let you see your rack without turning the house lights on, while the digital voltmeter lets you monitor incoming voltage.
RECORDING
Can’t track down where that noise is coming from? Your mix sounding flat? With standard level RFI/EMI filtration from Furman, you’ll lower the noise floor caused by the dirty AC power coming into your console or DAW. Standard level surge and spike protection from Furman keeps your sensitive digital equipment from acting funny or burning up due to everyday spikes and surges. You can even monitor voltage changes, as the digital meter allows you to keep an eye on the incoming line voltage. With a 15A capacity and nine total outlets, it’s enough to power your whole home studio.
DJ EQUIPMENT
Bars, clubs, and other event venues have some of the worst power out there—from air compressors turning on and off to light shows pulling current loads up and down, the AC power can be a strain on the circuits in your rig. Standard level protection and filtration from Furman keep the bad stuff out. The dual pull-out front panel lights also let you discreetly see your board and gear without distracting from the show on the dance floor.
PRO AUDIO
When you’re out there gigging, you never know what kind of power you’re going to get. The wear and tear on mobile rigs eventually takes its toll—that’s why it’s smart to plug into standard level protection and RFI/EMI filtration from Furman. It keeps your equipment safe and sounding clean, while the digital voltmeter lets you monitor incoming voltage. Whether you’re setting up a show at the local club or powering up the church band for their next service, make sure you give them power they can trust.
Specifications
- Spike Protection Modes: Line to Neutral
- Energy Dissipation: 150 joules
- Peak Impulse Current: 12,000 amps
- Maximum Continuous Operating Voltage: 130 VAC RMS
- Line Voltage: 120 (Volts)
- Number of Outlets: 9
- Number of Isolated Banks: 0
- Outlet Descriptions: All 9 outlets filtered and surge protected
- Rack Mountable: Yes
- Rack Ears Included: Yes
- Front Panel Meter(s): Digital Voltmeter
- Front Media Light(s): Two 120V incandescent bulbs, 4 watts each
- Control: Front panel On/Off switch, Light dimmer knob
- Voltage Regulation: No
- Compliance: cTUVus
- USB Charging: N/A
- Low Voltage Trigger: N/A
- AC Power Cord: 6 ft. captive, 14 AWG, with 3-conductor Edison Plug
- Dimensions: 19″ W x 7.5″ D x 1.75″ H
- Weight: 6 lbs
- AC Protection Technology: Standard spike and surge protection
- Under-Voltage Shutoff: N/A
- Maximum Continuous Operating Voltage Shutoff: 130 VAC RMS
- Maximum Current Rating: 15 Amps
- Filtration Technology: Standard Level RFI/EMI Filtration
- Filtration Rating: Greater than 26dB, 200Khz to 10 Mhz
- Signal Line Protection: No
- Construction: Steel Chassis, Black Painted
- Proposition 65 Warning
- WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
